Gme TX3120S User Manual download pdf (Page 18)

PAGE 18 INSTRUCTION MANUAL TX3120S

IMPORTANT: Channels 1 – 8, 31 – 38, 41 – 48

and 71 – 78 should only be used in Simplex mode

if there are no repeaters in or near your location

that operate on the selected channel. In particular,

avoid operating in Simplex mode on any of the

repeater input channels 31 – 38 and 71 – 78

unless you are absolutely sure that there are no

repeaters in range using that channel. Inadvertently

transmitting on an active repeater input frequency

in simplex mode could cause interference to other

users on that repeater that would not be audible

to your radio.

PRIORITY CHANNEL

The Priority channel feature allows you to instantly

recall any one of the 80 channels in your radio.

This feature can be used to provide instant access

to your working channel or your local repeater

channel at the press of key. It is also used in

conjunction with the Group Scan mode.

To store a Priority Channel;

1. Press and hold the Channel control to enter the

menu. The display will show the current Squelch

level setting.

2. Rotate the Channel control until ‘PRIxx’ is

displayed (where xx is a number from 01 - 80),

then press the Channel control to select it.

3. Rotate the Channel control to select your

required priority channel number.

When ﬁnished press and hold the Channel control

to exit the menu.

Priority channel = 80

To recall a Priority Channel;

Brieﬂy press the Channel control. The radio will

immediately switch to the Priority channel. The

priority channel is identiﬁed by the * icon.

Priority

Channel

Icon

NOTE: If the radio was scanning when the Priority

channel was recalled, the scan will be cancelled.

SCANNING

Your radio incorporates a scan function allowing

selected groups of channels to be scanned for

signals. Channels can be scanned at a rate of

45 channels per second. When a signal is found,

scanning will pause to allow the signal to be heard

then resume scanning when the channel is clear

again.

Scan Groups

Your radio supports three scan groups - Open Scan,

Group Scan and Network Scan. Each scan group

has separate channel memories allowing you to

program your choice of channels into each group

for scanning.

Selecting a Scan Group

To select Open Scan, Group Scan or Network Scan;

1. Press and hold the Channel control to enter the

menu. The display will show the current Squelch

level setting.

2. Rotate the Channel control until ‘OPEN’,

‘GROUP’ or NETWK’ is displayed, then press the

Channel control to select it.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments

Gme TX3120S User Manual Page 18

Comments to this Manuals

Related products and manuals for Walkie Talkies Gme TX3120S